subdirectory_arrow_left subdirectory_arrow_left Dual-Channel Power Amps
Gear Dual-Channel Power Amps {{currentManName}}swap_horiz Crownswap_horiz Find a manufacturerkeyboard_arrow_down

Comments about the news: Crown Updates Macro-Tech i Series Amps

Crown announced the latest update to its Macro-Tech i series of amplifiers, featuring increased power and new dual port capability.

Read the news item

This thread was created following the publication of a news item. Please feel free to post your comments about it in here!
i have the 9000i amp it has one network port and has less power than 9000i amp listed on the up graded.. --i want to buy another 9000i but want the same power as the power listed when i bought it.. Like 2 ohms 2500 watts--i will need the single network port correct --
I used to own a crown amp but then switch to Spyn Audio power amplifiers like SRX3300

check that outtttttt :D
Rated Power
1 kHz,THD+N=0.1% 8 ohms stereo 2 x 1200W
4 ohms stereo 2 x 1650W
2 ohms stereo 2 x 2200W
8 ohms bridge 3300W
4 ohms bridge 4400W
Protection DC protection Yes
Short circuit protection Yes
High temperature protection Yes
Current inrush protection Yes
Input over load protection
(limiter) Yes
Output over load protection Yes
Soft startup protection Yes
Frequency response
1W 8 ohms stereo 20 Hz–20 kHz (+/0.5dB)
8 ohms stereo, 1kHz 0.775V, /32dB, /36dB
Mode Stereo / Bridge / Parallel
Fan speed regulation Two-speed
Connectors (Each channel) Input connectors 1/4” Jack & Female Neutrik XLR
Output connectors Binding post & Speakon
Filter capability 10000uF/100V x 12
Input impedance Balanced 20K
Unbalanced 10K
20 Hz~20 kHz
Rated Power 8 ohms ≥60dB
S/N ratio Rated Power 8 ohms ≤100dB
Damping factor 1kHz, 8 ohms 650
Intermodulation distortion ≤0.5%
Total harmonic distortion
Phase response 1W, 8 ohms 20 Hz–20 kHz Within ±10°
Slew rate ≥25V/us
Output Circuitry Class H+
W x H x D 19 x 5 x 19 inches
482 x 132 x 483 mm
Rack Space 3U
Weight 83 Lbs./32 Kg

got this from there site~